Страница 74 из 98

A Call for armed insurrection

Talk about the delay systems now. It's a fuse, of course. But it is not always possible to solve the question alone with only a fuse. Sometimes more serious measures are required! Suppose you decided to blow up the ministry. They put it under 50 pounds of dynamite. Detonation needs to be strictly made at 15:00. You need to leave the sabotage site. It requires 30 minutes of time. Of course, making a multi-meter fuel is uncomfortable. Such cases require a delay system. About the assembly of the last I'll tell you now.

The best delays are, of course, the system electrical. They do this way. There is an ordinary filament lamp on 2.5 or 3.5 volts. The is being assaulted by wires. The lamp container is crashed. It's about the best thing to do is not damage the spiral. The latter constitutes a mixture that includes nitrocellulose glue and a sparkling substance. The lamp is reinforced in a paper cartridge, which is also filled with explosives. The latter is sealed with a dust, and then fits inside the detonator. There is another way. A hole is made in the lamp cylinder with the help of a man. Through it, explosives are pouredinside. The hole is then sealed with glue. This method is good because the probability of damage to the spiral is lower. As an incendiary composition, you can use aluminium gunpowder or bertolet salt. If there is no incandescent bulb, you can apply an ordinary nomerom wire. The main thing is that it is thin enough.

I told you the lamp should be soldered with wires. The only question is what wires. Of course, we are talking about wires on which the electric current moves. The latter warms up the lamp arc, which leads to detonation. Explosion, however, should occur not when, but at a particular time. I'll tell you about how to do it now.

A radio-controlled bomb. This thing is done like this. First, we'll need a radio-controlled model on an electric motor. Keep in mind: this last one has to be powerful enough. As for the transmitter, it should have a long range. At least 20 meters! The model will have to be disassembled, and the electronic scheme will take out. The wires leading from the power battery to the engine are then disco

You can also make a system that responds to movement. To do this, we'll need a motion sensor. Such that from the recorded vibrations immediately begins to make terrible sounds. Such sensors are sold in large quantities. It's not hard to find them. So: the wires leading to the dynamics need to be disco

Let's talk about the clock system now. She has become more accustomed to the mass consciousness. As soon as it comes to bombs, the everyman immediately imagines a ticking clock. Now about manufacturing. If we want to assemble this mechanism, we will need an electric alarm clock. It is desirable that a melody, rather than short beeps, be used as a signal of the latter. The case of the watch should be carefully disassembled. The wires leading to the speaker are detached. Thespeaker itself is taken away. Then you need to solder these wires to the electric arc. The one we talked about. Let's say now a few words about activation of this device. To begin with, you will need to set the exact time on the clock. Then you should turn on the alarm mode. After that, you need to set the right time to trigger the alarm. Only then does the electric arc co